Roof replacement cost in Denver, CO

How much does a roof replacement cost in Denver?

A roof replacement in Denver typically costs $13,730 for the example home. The range is $10,710 to $18,400. That is a tear-off of one layer of shingles and a new architectural asphalt roof. It is not a metal roof, not a tile roof, and not a second story added under the old one. The price uses a planning roof area of 1,955 square feet, which is the example home’s 1,700 square feet of floor times 1.15. That 1.15 is a stand-in for a simple roof. It is not a measurement. A steep roof, a complicated hip, or a measured square count replaces it the day someone is on a ladder.

What Denver labor does to a roof

The national starting point is $6.80 per square foot of that planning roof, before the city. About 52 percent of the price is the crew. Denver labor is 1.06 times a national crew, which adds about $440 versus a crew priced at 1.00. The typical price works out to about $10 per square foot of planning roof. Materials, the shingles themselves, barely move between cities. The hours do. A low labor factor is not a cheap roof if the deck is rotten.

Low, typical, and high on a Denver roof

Low, $10,710, is one layer, a walkable pitch, a driveway the dumpster can sit in, and decking that does not need sheets. Typical, $13,730, is that same scope on the example house, built around 1978. brick ranches and newer drywall tracts, dry cold, strong sun High, $18,400, is the same shingles when access is worse, the permit takes a second trip, or a few boards are replaced and hauled. A full redeck, a second layer that has to come off, ice-and-water on a whole valley system, or a crane is a different project and can sit above the high number without anyone cheating.

What the climate does, and what it does not

Denver is zone 5B, with about 6,000 heating degree days and 770 cooling degree days. Heat and hail and coastal wind change which shingle and which underlayment a roofer specifies. They do not, by themselves, multiply this table. Denver's labor factor is only slightly above national, and the design season is heating plus sudden hail. Cooling loads are real because of sun, not because of humidity. A condenser that has been hailed is a replacement, not a cleaning, and it is not inside a 'new mini-split' range. Altitude does not change Wellholt's Btu sketch; a contractor who claims it doubles the tonnage owes you the Manual J. Ask the quote to name the shingle line, the underlayment, and whether the deck is included. A price with no scope is not comparable to $13,730.

If you rent, and if the number is for the wrong house

A renter does not replace a roof. Use the range only to understand a building-wide assessment, not to hire a roofer. An owner with a different floor area should not use 1,955 square feet. Set your square footage in the calculator. A 1,000 square foot ranch and a 2,400 square foot two-story are not the same roof, and this page will not pretend they are. Reviewed 2026-09-01. Planning model: IECC climate zone, degree-day normals, a metro labor factor, and a residential rate used only for operating-cost context. Installed costs start from published national ranges and scale the labor share. Rents are planning medians, not listings. Reviewed 2026-09-01.

Before you sign in Denver, ask three things: how many squares they measured, whether the deck is included, and what happens if they open the roof and find more than a few bad boards. The planning figure here is $13,730 at labor 1.06, on a 1978 home. If their measurement is different, their price should be different. Do not argue them down to this number if they measured a larger roof.