Skip to content
WellholtAquarium & terrarium tools for every keeper.

Volume, Dimensions & Structural · Free tool

Aquarium Sump Volume Calculator: Operating Capacity and Freeboard

A sump adds water volume and equipment space beneath or beside an aquarium, but its normal operating level is usually lower than the top of its walls. This calculator estimates both the full geometric volume and the volume at a chosen operating fill percentage. It is a useful first step when comparing sump dimensions or keeping a system record.

Keep your tank details on this device. Set up your tankSaved locally in this browser. Sign in to sync and back up when account sync is configured.
Measure the usable internal length.
Measure the usable internal width.
Measure internal height from the base.
Estimate the operating water height as a percentage of the internal wall height.
Use the same unit for all dimensions.
Your resultEnter your values to calculate.

How this calculator works

Full geometric sump volume = internal length × width × wall height. Operating volume estimate = full volume × operating fill percentage.

Before you rely on the result

The fill-percentage method estimates the operating volume but does not calculate power-off drain-down or baffle-specific chamber levels. Leave suitable freeboard and test the system safely before relying on a sump design.

Practical guide

Aquarium sump volume planning guide

A sump adds water volume and equipment space beneath or beside an aquarium, but its normal operating level is usually lower than the top of its walls. This calculator estimates both the full geometric volume and the volume at a chosen operating fill percentage. It is a useful first step when comparing sump dimensions or keeping a system record.

Measure usable internal dimensions

Use the inside length, width and total wall height. If braces, baffles or chambers change the available space, the simple rectangular estimate will not describe every compartment exactly. The unit selector applies to all three dimensions, so enter inches for every measurement or centimetres for every measurement. Do not mix measurement systems in the same calculation.

Operating volume is not the same as full capacity

A sump is not normally filled to its rim. The operating waterline leaves room for water that can drain back from the display tank and plumbing when the return pump stops. The percentage input estimates the volume at a typical operating level, but it does not calculate drain-back, individual chamber heights, evaporation range or the extra capacity needed during a power outage. Those factors must be checked in the actual system.

Test freeboard before relying on the sump

After installation, check the normal running level and simulate a safe pump-off condition while monitoring the water level. Make sure the sump can accept drain-back without overflowing and that the return pump remains safely submerged during operation. Allow for equipment displacing water and for the effect of baffles. The calculated volume helps with planning, but it cannot replace a physical test of the plumbing and sump design.

Common questions

Frequently asked questions

What is sump operating volume?

It is the approximate water volume at the normal running level, rather than the volume up to the top of the sump walls.

Does this calculate how much water drains back when the pump stops?

No. You must evaluate the display-tank waterline, plumbing and anti-siphon behavior in the installed system and confirm adequate freeboard.

Should I fill the sump to 100 percent?

Usually not during operation because space is needed for drain-back and changes in water level. Follow your design requirements and test the system safely.

Important: WellHolt tools provide estimates and educational guidance, not veterinary, medical, electrical or engineering advice. Follow product labels and species-specific husbandry guidance.